semi bricked Pendo pad

[Harachai]

In its current state it is , semi bricked, it was fully bricked but using the needle trick i was able to get it partially recognised
boot code test ok
but fails at id block writing for any image i try
RKAndroidDM program fails to recognise it, even while using the needle trick
what RKAndroidBatchUpgrade 1.23 looks like when i try to use it with an image from the pad site
Pendo Industries Pty Ltd. PendoPad Firmware - Downloads - Support Pendo Industries Pty Ltd.

when i try to use RKAndroidTool_v1.23 (found one that gives english errors)
i get this

for a brief moment it went as far as the batch tool but both get
Start writing ID BLOCK...
WRITING ID BLOCK fail.

pad details :
Here are the details for the pad

cpu: 1ghz
memory: 256mb
Nandflash HDD : 2gb
card slot: microcard sd slot
screen: 800x480 7inch blue led, resistive
modem : unknown
G-sensor
Model number : TPC7SLV

top view
Port veiw : left to right power, USB (modem?), on/off, usb (data), card, microphone
Inside view
http://i47.tinypic.com/b695ra.jpg
link for chip view

when i did cat /proc/mtd on the tablet before i bricked it i got
mtd0: 00002000 00000010 "misc"
mtd1: 00004000 00000010 "kernel"
mtd2: 00002000 00000010 "boot"
mtd3: 00004000 00000010 "recovery"
mtd4: 00030000 00000010 "system"
mtd5: 0003a000 00000010 "backup"
mtd6: 0003a000 00000010 "cache"
mtd7: 00100000 00000010 "userdata"
mtd8: 00cbc000 00000010 "user"
mtd9: 00020000 00000010 "pagecache"
mtd10: 00020000 00000010 "swap"

nothing in the backup that i could get to.

Any help on how i can unbrick it, or how to get the write ID block to not fail?

Thanks!